Liebherr Power failure: power came back with the cabinet above its limit
After an interruption in the power supply, Touch & Swipe models show Power failure if the cabinet is above the alarm limit when power returns.
Mon–Sat, 8am–8pm
- Power
- Wine cooler diagnostic visit
- Source: Liebherr
Book a visit
Three short steps, about a minute.
or call (844) 709-0727
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Power failure
actually means.
After an interruption in the power supply, Touch & Swipe models show Power failure if the cabinet is above the alarm limit when power returns. Pressing confirm shows the warmest temperature reached; pressing again ends the alarm and shows the current temperature. Liebherr asks you to check the stored goods.
Liebherr wine cooler display · also shown as Power failure alarm
What to do when Power failure shows on the wine coolerKind of codePower
The cooler saw the supply voltage dip, surge or drop out, or is recording that the power was cut while nobody was home. The cause is as often the outlet, a shared circuit, an extension cord or a storm outage as the cooler itself. A breaker that will not hold or a whiff of hot plastic means cutting the circuit at the panel, standing dry and clear of the cooler, then leaving the glass door closed until the technician arrives.
Usually leads toWine cooler diagnostic visit
A visit that measures each zone and the room around the cabinet first, then works through the door seal, the airflow, the sensors and the cooling system until one part is named.
Shows up asWine Cooler Error Code
A wine cooler error code appears as letters and digits on the display, a flashing temperature, dashes where a number should be or a blinking symbol, sometimes with an alarm tone and sometimes while the cabinet stays perfectly cool.
MakeLiebherr
Liebherr wine cooler repair for cabinets that swing in temperature, run too long or build up moisture inside.
SourceLiebherr W5250 operating instructions, equipment messages
Liebherr Touch & Swipe wine cabinets such as UW3720 and W5250.
Before you book,
in this order.
Each step comes from Liebherr's own guidance for Power failure on its wine coolers. Follow it to the end: the last card says whether this is a visit.
Press confirm and note the warmest temperature displayed.
Keep the door shut while the cabinet cools back to its setting.
If outages keep happening with power on in the rest of the house, book a visit for the power supply.
Still there?
It usually turns into wine cooler diagnostic visit. Book with the code and the model number.
What not to do
Power failure reports the house supply, not a failed part. A cabinet that trips its breaker or will not restart is a different problem.
What you may
notice with it.
The wine cooler problems Power failure tends to arrive with. Answer these at the wine cooler before anyone is booked.
All problems
Wine Cooler Error Code
7 causes, cheapest first
Liebherr
wine coolers.
Liebherr wine cooler repair for cabinets that swing in temperature, run too long or build up moisture inside.
Liebherr wine cooler repairMore Liebherr codes
Power on other makes
Undercounter wine cooler
A wine cooler about the height of a base cabinet, built in under the counter of a kitchen, a bar or a butler's pantry, with a glass door, sliding racks and a vented toe grille at the floor.
Wine column
A full-height built-in wine cabinet, 18 to 30 inches wide, set flush into tall cabinetry or paired with a matching column, with a glass or panel door and dozens to well over a hundred bottles inside.
Freestanding wine cooler
A wine cooler that stands on its own in a dining room, a den or a basement, cooled either by a compressor or by a thermoelectric module, and vented at the back or the sides.
In Liebherr's own words
interruption in the power supply
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Liebherr Touch & Swipe wine cabinets such as UW3720 and W5250.
Liebherr Power failure wine cooler repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Power failure.
Can I clear Power failure myself?
Should I throw out wine after a Liebherr Power failure message?
Why does the message appear even though power is back?
Does the SabbathMode survive an outage?
Back to your everyday
Still showing Power failure?
When you book, copy the code or the blink pattern as the display shows it, add the whole model number, and say whether the bottles still feel cool — a code gives the technician a head start.