Miele under-counter wine unit F1 to F3 or S1 to S9: a problem only service can clear
On Miele's under-counter wine conditioning units, the codes F1 to F3 and S1 to S9 are listed together in the problem guide as an internal problem for Miele's technical service.
Mon–Sat, 8am–8pm
- Control board and display
- Wine cooler control board and display repair
- Source: Miele
Book a visit
Three short steps, about a minute.
or call (844) 709-0727
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F1 to F3, S1 to S9
actually means.
On Miele's under-counter wine conditioning units, the codes F1 to F3 and S1 to S9 are listed together in the problem guide as an internal problem for Miele's technical service. Miele does not publish what each number refers to, and it gives the owner no reset. The number itself is what the technician needs.
Miele wine cooler display · also shown as F1, F2, F3, S1, S9
What to do when F1 to F3, S1 to S9 shows on the wine coolerKind of codeControl board and display
The electronics that read the sensors and switch the cooling, the fans and the lights have reported a problem with themselves or lost touch with the display. A loose ribbon cable, moisture that reached the touch strip or a brief power surge is checked before a board is condemned. Boards and displays are usually specific to one model, so the number on the label matters here more than anywhere.
Usually leads toWine cooler control board and display repair
Repairing the electronic control and the touch display that run a wine cooler, from a blank screen or a code to keys that will not respond or a cabinet that will not start.
Shows up asWine Cooler Error Code
A wine cooler error code appears as letters and digits on the display, a flashing temperature, dashes where a number should be or a blinking symbol, sometimes with an alarm tone and sometimes while the cabinet stays perfectly cool.
MakeMiele
Miele wine cooler repair in the home, with each zone measured and the bottles left undisturbed wherever possible.
SourceMiele KWT 6322 UG operating instructions, problem guide
Miele KWT 6322 UG under-counter wine conditioning units (en-US manual M.-Nr. 10 036 280). The MasterCool columns show an F message in words instead.
Before you book,
in this order.
Each step comes from Miele's own guidance for F1 to F3, S1 to S9 on its wine coolers. Follow it to the end: the last card says whether this is a visit.
Write down or photograph the exact code in the display.
Check the zone temperatures; if a zone is warm, keep the door shut and move the most valuable bottles to a cool dark place.
Book a visit and give the code and the model number from the data plate inside the unit.
Still there?
It usually turns into wine cooler control board and display repair. Book with the code and the model number.
What not to do
These codes are not a door or temperature alarm, which the unit shows with its alarm symbol instead. A dash in the display is also different: it only means the temperature is outside the range the display can show.
What you may
notice with it.
The wine cooler problems F1 to F3, S1 to S9 tends to arrive with. Answer these at the wine cooler before anyone is booked.
All problems
Where F1 to F3, S1 to S9 usually leads
Wine cooler control board and display repair.
Miele
wine coolers.
Miele wine cooler repair in the home, with each zone measured and the bottles left undisturbed wherever possible.
Miele wine cooler repairMore Miele codes
Control board and display on other makes
Undercounter wine cooler
A wine cooler about the height of a base cabinet, built in under the counter of a kitchen, a bar or a butler's pantry, with a glass door, sliding racks and a vented toe grille at the floor.
Wine column
A full-height built-in wine cabinet, 18 to 30 inches wide, set flush into tall cabinetry or paired with a matching column, with a glass or panel door and dozens to well over a hundred bottles inside.
Dual-zone wine cooler
A wine cooler with two separately set compartments, upper and lower or side by side, so reds and whites or a storage zone and a serving zone each keep their own temperature.
In Miele's own words
"F1" to "F3" or "S1" to "S9" appear.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Miele KWT 6322 UG under-counter wine conditioning units (en-US manual M.-Nr. 10 036 280). The MasterCool columns show an F message in words instead.
Miele F1 to F3, S1 to S9 wine cooler repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F1 to F3, S1 to S9.
Can I clear F1 to F3, S1 to S9 myself?
Does F2 on a Miele wine unit mean something different from F1?
Can I clear an S code on a Miele under-counter wine unit?
Is the wine at risk when an F or S code appears?
Back to your everyday
Still showing F1 to F3, S1 to S9?
When you book, copy the code or the blink pattern as the display shows it, add the whole model number, and say whether the bottles still feel cool — a code gives the technician a head start.