The top trim of a wine column lowered to show a small green circuit board behind the touch display, a ribbon cable running from it to the control strip.

ASKO E0: the power board and the display are not talking

E0 reports a break in communication from the power board to the user interface electronics that run the touch screen.

(844) 709-0727

Mon–Sat, 8am–8pm

  • Control board and display
  • Wine cooler control board and display repair
  • Source: ASKO

Book a visit

Three short steps, about a minute.

or call (844) 709-0727

What E0
actually means.

E0 reports a break in communication from the power board to the user interface electronics that run the touch screen. The cabinet may still cool, but the display cannot show or change what the power board is doing. ASKO asks owners to confirm the message and to contact service if it keeps returning.

ASKO wine cooler display

What to do when E0 shows on the wine cooler

Before you book,
in this order.

Each step comes from ASKO's own guidance for E0 on its wine coolers. Follow it to the end: the last card says whether this is a visit.

01

Tap X or Confirm on the pop-up to close it; the cabinet shows it again after 3 hours if the problem is still there.

02

Check that each zone is still holding its temperature on the display or in the ConnectLife app.

03

If E0 returns, book a visit and note whether E8 appeared with it.

Still there?

It usually turns into wine cooler control board and display repair. Book with the code and the model number.

What not to do

E0 is not a sensor or fan problem, and it does not say the cabinet is warm. E8 is the same break seen from the other direction, from the display to the power board.

What you may
notice with it.

The wine cooler problems E0 tends to arrive with. Answer these at the wine cooler before anyone is booked.

All problems

Where E0 usually leads

Wine cooler control board and display repair.

Main control board, display board or door switch · moderate to highest.

In ASKO's own words

Communication error from power board to user interface electronics.
ASKO WCN311942G Instructions for Use, error notifications ASKO WCN311942G Instructions for Use, repeat after 3 hours

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. ASKO WCN311942G three-zone wine climate cabinet (zones A, B serving area, and C), sold in the US; the table in its Instructions for Use applies to this model family.

ASKO E0 wine cooler repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A couple choosing a bottle together from an undercounter wine cooler in a warm kitchen at dusk
For the heart of your home.

Questions
about E0.

Can I clear E0 myself?
Tap X or Confirm on the pop-up to close it; the cabinet shows it again after 3 hours if the problem is still there. If it comes back, it needs a visit.
Will my ASKO wine cabinet keep cooling with E0?
Often it does, since the power board runs cooling; the problem is the link to the screen. Watch the zone temperatures until the visit.
Is E0 on ASKO the same as E8?
Both are communication breaks between the power board and the display electronics, reported from opposite ends. Either one points to the boards or the cable between them.
Can a power reset clear ASKO E0?
ASKO gives confirming the message as the owner step. If the break is real, the code returns within hours.

Back to your everyday

Still showing E0?

When you book, copy the code or the blink pattern as the display shows it, add the whole model number, and say whether the bottles still feel cool — a code gives the technician a head start.

(844) 709-0727 Schedule a repair