Vinotemp LO: the cabinet has dropped below freezing
On VT-DS built-in models LO appears when the cabinet air falls below 32°F, and the alarm sounds with the malfunction indicator light at the same time.
Mon–Sat, 8am–8pm
- Temperature and alarms
- Wine cooler thermostat and sensor repair
- Source: Vinotemp
Book a visit
Three short steps, about a minute.
or call (844) 709-0727
Loading appointment form…
The appointment form couldn’t load. Please try again.
What LO
actually means.
On VT-DS built-in models LO appears when the cabinet air falls below 32°F, and the alarm sounds with the malfunction indicator light at the same time. The coldest setting on these models is 39°F, so LO means the unit is cooling past what it was told to do, not that the setting is low.
Vinotemp wine cooler display
What to do when LO shows on the wine coolerKind of codeTemperature and alarms
The cooler read a zone well away from its setting and raised an alarm, sometimes showing the warmest figure it reached while the house was empty. The reason may be as small as a door left resting on a bottle neck or a long outage, or as serious as cooling that has stopped. Keep the glass door shut and feel a bottle in the middle of the rack before doing anything else; the alarm is a warning about the wine, not a diagnosis.
Usually leads toWine cooler thermostat and sensor repair
Testing and replacing the thermostat or the temperature sensors that tell a wine cooler when to cool, when the cabinet runs too cold, too warm or back and forth.
Shows up asWine Cooler Error Code
A wine cooler error code appears as letters and digits on the display, a flashing temperature, dashes where a number should be or a blinking symbol, sometimes with an alarm tone and sometimes while the cabinet stays perfectly cool.
MakeVinotemp
Vinotemp wine cooler repair at home, planned around the model plate and what the cabinet is doing.
SourceVinotemp VT-DS15 / VT-DS24 built-in models owner's manual
VT-DS15 and VT-DS24 built-in wine (WC) and beverage (BC) models. Private Reserve units flash the temperature display instead, and the Connoisseur and Butler manuals list no HI or LO.
Before you book,
in this order.
Each step comes from Vinotemp's own guidance for LO on its wine coolers. Follow it to the end: the last card says whether this is a visit.
Check the set temperature; the adjustable range is 39°F to 64°F.
Look over the bottles near the back wall for ice or corks that have started to push out.
Unplug the unit for 5 minutes, plug it back in and watch the display.
If LO returns, book a visit; a cabinet that overcools on a normal setting needs its sensor and control checked.
Still there?
It usually turns into wine cooler thermostat and sensor repair. Book with the code and the model number.
What not to do
LO does not mean the dial is simply set low, because the lowest setting is 39°F and LO starts below 32°F. It is also not a sensor code; other Vinotemp series report a failed sensor as E1, E2, EL or EH.
What you may
notice with it.
The wine cooler problems LO tends to arrive with. Answer these at the wine cooler before anyone is booked.
All problems
Where LO usually leads
Wine cooler thermostat and sensor repair.
Vinotemp
wine coolers.
Vinotemp wine cooler repair at home, planned around the model plate and what the cabinet is doing.
Vinotemp wine cooler repairMore Vinotemp codes
Temperature and alarms on other makes
Undercounter wine cooler
A wine cooler about the height of a base cabinet, built in under the counter of a kitchen, a bar or a butler's pantry, with a glass door, sliding racks and a vented toe grille at the floor.
Freestanding wine cooler
A wine cooler that stands on its own in a dining room, a den or a basement, cooled either by a compressor or by a thermoelectric module, and vented at the back or the sides.
Dual-zone wine cooler
A wine cooler with two separately set compartments, upper and lower or side by side, so reds and whites or a storage zone and a serving zone each keep their own temperature.
In Vinotemp's own words
If the inner temperature is lower than 32°F (0°C), “LO” is shown on the display panel
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. VT-DS15 and VT-DS24 built-in wine (WC) and beverage (BC) models. Private Reserve units flash the temperature display instead, and the Connoisseur and Butler manuals list no HI or LO.
Vinotemp LO wine cooler repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about LO.
Can I clear LO myself?
Can I set my Vinotemp cold enough to cause LO?
Why did a red light come on with LO?
Are my bottles safe after a Vinotemp LO alarm?
Back to your everyday
Still showing LO?
When you book, copy the code or the blink pattern as the display shows it, add the whole model number, and say whether the bottles still feel cool — a code gives the technician a head start.